FREE SHIPPING ON ORDERS OVER €120 IN THE PENINSULA

Franklin Audio MP-10 Mic to Inst Pre-Amp

Franklin Audio MP-10 Mic preamp for running microphones into guitar pedals (with +48V)

Balanced XLR in + Mic Thru · Mic level to instrument level conversion · 12–60 dB gain · −20 dB pad · GND + polarity switches · Switchable +48V phantom · 9V center-negative · Made in Australia

Leer más >

 279,00 VAT included

In stock

DESCRIPTION

Franklin Audio MP-10 Mic preamp for running microphones into guitar pedals (with +48V)

Balanced XLR in + Mic Thru · Mic level to instrument level conversion · 12–60 dB gain · −20 dB pad · GND + polarity switches · Switchable +48V phantom · 9V center-negative · Made in Australia

The Franklin Audio MP-10 is a compact microphone preamp built for one purpose: letting you plug any microphone into any pedal with proper level, impedance, and gain staging. It converts low-level mic signals into instrument-level output for pedals, and provides switchable +48V phantom power for condenser mics when needed.

It’s made for both stage and studio workflows. Run vocals or mic’d instruments through your pedalboard (delay, chorus, fuzz, anything), while preserving a clean feed via the balanced Mic Thru—perfect for sending a dry signal to FOH or capturing a clean track alongside your effected chain in the studio.

MP-10 offers 12–60 dB of gain, with clear status LEDs and practical utility switches: −20 dB PAD for hot sources, GND to reduce hum from ground loops, and polarity (Ø) to invert phase when required. Power it from standard 9V center-negative pedal power.

Key features

  • Mic preamp designed to run microphones into pedals
  • Conversion: mic level → instrument level with proper impedance
  • Balanced XLR Mic In + balanced XLR Mic Thru (dry duplicate)
  • 1/4″ unbalanced instrument output to pedals
  • Switchable +48V phantom power
  • Gain range: 12–60 dB
  • −20 dB PAD
  • GND switch to alleviate ground loop hum
  • Polarity (Ø) switch for phase inversion
  • LEDs: output level, +48V, and 9V indicators
  • Runs on standard 9V center-negative pedal power
  • Made in Australia

Technical specifications

  • Input: balanced XLR Mic In
  • Dry output: balanced XLR Mic Thru (duplicate of input)
  • Pedal output: 1/4″ TS unbalanced (instrument level)
  • Power: 9V DC center-negative
  • Gain: 12–60 dB
  • Pad: −20 dB
  • Switches: GND / Ø / +48V
  • Manufacturer: Franklin Audio · Made in Australia

Find the Franklin Audio MP-10 and a curated selection of boutique studio/stage tools at onemorepedal.com, your specialist store for creative signal solutions.

Run a mic into pedals—without the headaches.